Direct answer: The UPLIMARK catalog lists UGN-X0624 as a 0.13 mm PTFE seal sheet and identifies it as a compatible replacement unless stated otherwise. Before ordering, match the printer and installed assembly reference, required sheet dimensions, cut profile, measurement convention and fluid application against the part in your machine or its service specification. The listed thickness alone does not prove that a cut gasket will fit or that the material suits every ink or solvent.
What the listing verifies—and what it does not
The product record identifies PTFE sheet, a nominal thickness of 0.13 mm and the reference UGN-X0624. It does not establish a universal printer fit, finished gasket dimensions, a specific cut pattern, or chemical compatibility with every fluid. Treat this as a sheet-material listing, not confirmation that it is a ready-to-install gasket.
Checks to make before ordering
1. Record the printer model and the part number on the installed seal or assembly. Compare those details with the exact listing; do not infer compatibility from material or thickness alone.
2. Measure the existing part or use the applicable service drawing. Confirm length and width, the order in which dimensions are stated, units, thickness and the required profile, including holes or cut-outs. A dimension string is ambiguous unless its measurement convention is clear.
3. Confirm the fluid and operating application using the machine documentation or an authorized service source. PTFE is the catalog material, but that fact by itself is not proof of suitability for every ink, solvent, temperature or duty cycle.
4. Ask whether the supplied item is sheet stock or a finished cut component, and confirm the quantity and scope before placing an order. Do not assume cutting, extra seals or hardware are included unless the listing says so.
5. If any reference, dimension or application detail is uncertain, send the installed part reference, printer model, clear photos beside a ruler, required quantity and delivery country for a fitment review.
Safe maintenance boundary
Use the printer manufacturer’s service procedure and isolate the equipment as directed before opening a fluid circuit. Avoid improvising seal dimensions or substituting material based only on appearance. If the seal is in a pressurized or chemical-contact assembly, have a qualified technician verify the replacement and follow the applicable manual, safety data and site procedures. This guide is general purchasing information, not a repair instruction or chemical-compatibility certification.
Frequently asked questions
Is UGN-X0624 a finished gasket? The catalog identifies a 0.13 mm PTFE sheet; it does not confirm a particular cut profile or ready-to-fit shape. Verify the supplied form before ordering.
Does 0.13 mm thickness confirm fit? No. Match the part reference, dimensions, measurement convention, profile and application. Thickness alone is insufficient.
Is this sheet compatible with every CIJ ink or solvent? That is not established by the listing. Check the actual fluid and operating conditions against the equipment or material specification.
To request a check, include the printer model, current part reference, dimensions with units, clear photos, quantity and destination. See the compatibility and ordering guide, view the UGN-X0624 PTFE seal sheet listing, or contact UPLIMARK for a fitment review.
