Direct answer: For a Domino A320i or A420i, order this Type 2 ink-interface PCB only after confirming the installed board matches the Type 2, Variant 02 configuration and reference EAS003214SP. The store listing identifies UPLIMARK model UDM-EAS003214SP-02 as a compatible replacement for that specific configuration; printer model alone is not enough to establish fitment.
Match the installed board before ordering
Use the product reference as a starting point, then compare the part in the printer with the product listing. Confirm the complete UPLIMARK reference UDM-EAS003214SP-02, the listed OEM reference EAS003214SP, and the Type 2 / Variant 02 designation. The listing names Domino A320i and A420i systems using the exact Type 2 board variant; it does not establish compatibility with every board or revision used across those printer families.
Compare clear photographs of the installed component with the listing image. Check the board outline, connector positions, component population and mounting-hole locations. A photo helps identify visible differences, but it does not independently verify firmware, revision or serial-range requirements. If those details are uncertain, pause and request a fitment review.
What to send for a fitment check
- Printer model and, if available, serial-range or revision information from the machine records.
- The full reference printed on the installed board, including any suffix or variant marking.
- Clear photos of the complete board, its labels, connectors and mounting points. Take photos only when the equipment is safely isolated and accessible under the manufacturer's service procedure.
- Required quantity and delivery destination, so the supplier can confirm the quotation and shipping details.
Do not assume that a board with a similar part number, connector count or appearance is interchangeable. Do not remove or handle electronic assemblies unless qualified to do so and following the printer manufacturer's safety and service instructions.
See the CIJ compatibility and ordering guide for the information to prepare, and review the Type 2 Variant 02 ink-interface PCB listing for the product reference and images.
Frequently asked questions
Does A320i or A420i on the nameplate confirm the board will fit?
No. The product listing specifies the exact Type 2, Variant 02 configuration. Check the installed board reference and visible layout, then confirm any revision or serial-range requirements.
Is UDM-EAS003214SP-02 an original Domino part?
No original-parts status is claimed here. The listing identifies it as a UPLIMARK compatible replacement and gives EAS003214SP as the OEM reference.
Can I use a photo to confirm every compatibility requirement?
No. Photos help compare visible markings and layout, but firmware, revision and serial-range requirements may need separate confirmation.
Request confirmation before ordering
For this replacement part, send the printer model, installed reference, clear board and connector photos, quantity and destination through the CIJ Printer Parts contact page. Confirm fitment and current supply details with the supplier before placing an order.
Domino and model names are used only to identify the equipment referenced by the listing. CIJ Printer Parts is an independent supplier; this item is described as a compatible replacement, not as an original Domino part.